Home > Hp Psc > Hp Psc 1350 Error

Hp Psc 1350 Error

Contents

Try the intended task again. Disconnect the product cord from any power strip or surge suppressor, and then plug it directly into a three-prong wall outlet. Press and release the Color Start Copy button. Figure : Insert the cartridge Firmly push the cartridge in until it snaps into place. http://orgias.org/hp-psc/hp-psc-1350-error-e.html

Try the intended task again. Load plain white paper in the paper tray. If the issue persists, continue to the next solution. Close the cartridge access door.

Hp 1350 Printer Check Print Cartridge Error

Paper jam causes The following factors can cause paper jams: Paper loaded incorrectly in the paper tray. If the test page does not print, continue with the next solution. If these steps resolved the issue, you do not need to continue troubleshooting. Place your index finger in the finger slot on the paper tray at the front of the product.

Disconnect the power cord from the rear of the product. Press the Cancel button () on the control panel. Press and release the Paper Type button. Hp Psc 1350 Error Code E If these steps resolved the issue, you do not need to continue troubleshooting.

I wish i hadnt bought these new cartridges...but they told me i had too because we tried everything with the old ones..and nothing worked. The product makes loud grinding noises. The money spent on the new cartridges was a waste, but if you can sell them to someone, do it. http://h30434.www3.hp.com/t5/Inkjet-Printing/1350-all-in-one-PSC-printer-will-not-print/td-p/745757 This should get the carts talking with the printer again, if it is a communication error.

Before loading paper in the tray, hold the stack of paper, and then tap the bottom edge on a flat surface so that the stack is even on all sides. Hp Psc 1210 Check Print Cartridge Error Maybe I should try cleaning the contacts, unless you have any ideas.Thanks,IR12 Reply 0 0 Bob_Headrick Provost Posts: 27,159 Member Since: ‎11-17-2008 Message 7 of 13 (14,914 Views) Report Inappropriate Content Re: 1350 all-in-one PSC printer will not print Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎07-29-2011 09:57 AM I would suggest you follow the troubleshooting steps here. I've checked for loose paper, took the cartilages out and put them back in, checked the carriage for obstructions, and unplugged the printer and plugged it back in several times. Paper was added to a stack already in the tray while the HP product was printing.

Hp Psc 1350 Troubleshooting

If you think you have received a fake HP Support message, please report it to us by clicking on the blue “Report Inappropriate Content” button above the message. http://h30434.www3.hp.com/t5/Inkjet-Printing/HP-PSC-1350-All-in-One-Printer-Error-lights-blinking-and/td-p/3377873 Disconnect the power cord from the rear of the product. Hp 1350 Printer Check Print Cartridge Error Sign in 1 Loading... Hp Psc 1350 Manual When only the On/Resume button () is blinking, release both buttons.

If brand new printers didnt have cartridges ..i could just put these new ones in there...what printer can use the #56,57 ones u said u seen on hp website? http://orgias.org/hp-psc/hp-psc-1350-ink-cartridge-error.html Even when the fuel gauge on your computer screen says that they are empty, remember that this is only a clock, and that the reading it is giving you is only an estimate. If you have already installed the cartridges, proceed to the next solution to check cartridge compatibility. Fold out the paper tray extender to catch paper as it exits the device. Hp Psc 1315 Check Printer Cartridge Error

I got replacements from cartridge world and it worked fine for a couple of days. Make sure that the paper is free of rips, dust, wrinkles, and curled or bent edges, and that all the paper in the stack is the same size and type. Sign in to make your opinion count. Check This Out note: If the carriage does not move into the access area, turn the product off and then on again.

Reconnect the power cord to the rear of the product. Hp Psc 1210 Troubleshooting These are just so much cheaper.That, I'm going to leave you with that. If the issue persists, continue to the next solution.

This video shows how to replace the ink cartridges Click here to see this video in full screen on YouTube.

And since it changed back to E and also the printer didnt shut off..what does all this tell u about the printer? Close the cartridge access door by pressing firmly on the door until it snaps into place. If the product completes the job normally, there is no need to continue troubleshooting. How To Reset Hp Psc 1410 Printer Then it said check print cartridge.

Similar Threads - 1350 Wont Wont boot past aptio utility screen F0rdtuff, Oct 14, 2016 at 11:37 PM, in forum: Hardware Replies: 3 Views: 104 plodr Oct 15, 2016 at 7:52 PM have vertical lines on screen vidio card wont load error43 fixmycomputer123456, Oct 13, 2016 at 7:31 PM, in forum: Hardware Replies: 3 Views: 87 managed Oct 14, 2016 at 10:52 PM Does anyone have s Seagate Nas 220 that wont create volumes? Try the intended task again. note: You might need a flashlight to illuminate areas for proper viewing. http://orgias.org/hp-psc/hp-printer-1350-error.html Remove any loose paper Do not pull jammed paper Step two: Clear the paper jam from the rear of the All-in-One caution: Never pull jammed paper from the front of the product.

If the LED lights up, continue to the next step. Right-click this link, Product Support Home Page, and then click Open in New Window. While holding the Cancel button (), press and hold the On/Resume button (). note: If the carriage does not move into the access area, turn the product off and then on again.

Yes, the money on the cartridges is out the window unless you can sell them on Craigslist or something. Reply 0 0 Drakster Retired Posts: 3,859 Member Since: ‎06-22-2015 Message 6 of 6 (135 Views) Report Inappropriate Content Re: HP PSC 1350 All-in-One Printer - Error lights blinking and carriage problems Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎07-04-2016 10:18 AM Hi @Philosopher,Thanks for reaching out to the HP Support Forums!I see that you're experiencing problems with yourHP PSC 1350 All-in-One Printer.I will certainly do my best to help you and please remember to return to this thread and mark 'Accept as Solution', if I have successfully helped you resolve the issue. Close Yeah, keep it Undo Close This video is unavailable. Helio Benavides 12,829 views 0:31 Level reset instructions HP inkjet cartridge n.21 22 27 28 46 56 57 58 338 339 343 344 348 - Duration: 1:57.

González 3,421 views 2:05 HP #21 #22 #27 #28 #56 #57 晶片重置範例影片1080i - Duration: 1:50. 創達科技 31,379 views 1:50 Piscando luz verificar cartucho de impressão - Duration: 3:08. Follow these steps to determine which cartridge is defective, and then remove and replace that cartridge. Well what I'm going to show you today is a little bit about the printer but I figure you probably already know a little bit about it.I'm going to show you how to get support and information about it, how to fix it a little bit and I'm going to show you where to get the ink and what the best prices are on the ink.First it's kind of an old printer, 2003, I would call that old, 10 years old.They're not available new anymore so be it.It's got reasonable DPI for the time.USB Only and it doesn't have great reviews so I can't say I'd highly recommend it infact I don't.But, you're probably looking at this because you want to know something about it like how to fix it or how to get replacements for it.Well first of all when you get to HP support here's how to navigate this thing.There's 3 main things that I think you'll want to do.First is get drivers, that's in this tab right here, then you just select your operating system and go.Next, you'll download them and install them.You'll want to click out of any fancy bloatware they have to try and make your computer better just forget all that.Just install the drivers. note: Forcing the paper too far into the product might cause multiple sheets of paper to be fed through the print mechanism, or cause a paper jam.

caution: You must disconnect the power cord to move parts by hand without the risk of an electrical shock. Press the Scan button to try the scan job again. Pulling paper from inside the front cover can cause mechanical damage to the product. Remove the rear access door.

Go to HP SureSupply. I got replacements from cartridge world and it worked fine for a couple of days. I 'm trying to fix or solve this problem without having to take it somewhere to get fixed...because probably the cost of fixing it..i could buy a new printer..but i dont want to buy a new printer because u get cartridges with it...and i already bought 2 new ones..& the person i bought them from said i cant return them..even though they havent been used..(have been taken out of package and inserted in printer..but thats it..NO PRINTING with them) So if u have any other suggestions on how to solve this problem ..or what i can do next...it would be much appreciated!!. Before loading paper in the tray, hold the stack of paper, and then tap the bottom edge on a flat surface so that the stack is even on all sides.

Unplug the power cord from the wall outlet. Try the intended task again.