Home > Hp Psc > Hp Psc 1350 Error Lights

Hp Psc 1350 Error Lights

Contents

This video shows how to replace the ink cartridges Click here to see this video in full screen on YouTube. Melde dich an, um dieses Video zur Playlist "Später ansehen" hinzuzufügen. If the product turns on with the alternate power cord, the original power cord caused the issue. Load plain, white paper into the paper tray. Check This Out

Solution four: Service the All-in-One If you have completed all the steps and are still experiencing a problem, continue to the Service the All-in-One section at the end of this document. by GaryCClark on Jan 17, 2011 at 9:56am Add comment Please sign in to comment 0 I have posted before about my 1350 not printing red. With the product turned on, disconnect the power cord from the rear of the product. Thanks for your great sitebest regards.. http://support.hp.com/us-en/document/c00095908

Hp 1350 Printer Check Print Cartridge Error

Patty's by unknown on Mar 15, 2008 at 8:10am Add comment Please sign in to comment 0 Try these things before replacing it.1. IF YOU ARE USING RELOADS (either purchased reloads or having your carts reloaded yourself), you must make sure that the print head is free and clear of clots and gunk. If the On/Resume light () does not blink, replace the black cartridge. Figure : Remove scraps of paper Gently push the pins on the right end of the rear access door into the holes on the right side of the rear access area, and then snap the door firmly back into place.

I had a similar problem with my 1350 recently. I've checked for loose paper, took the cartilages out and put them back in, checked the carriage for obstructions, and unplugged the printer and plugged it back in several times. Press and release the Copies button. How To Reset Hp Psc 1410 Printer This page requires Javascript.

Figure : Remove the cartridge If the cartridge has protective tape covering the nozzles, use the pull tab to remove it. The 'Check Cartridge' light flashes. by unknown on Nov 24, 2008 at 8:38pm Add comment Please sign in to comment 0 This reply is for "ugh". http://support.hp.com/us-en/document/c00861481 Figure : Reinsert the cartridge Firmly push the cartridge in until it snaps into place.

I have uninstalled and reinstalled drivers and cleaned the area recommended, but it still shows the cartridge as empty. Hp Psc 1350 Manual I guess this is where the prob lies? If the settings in the Paper/Quality tab are incorrect, change the settings to match the paper loaded in the paper tray. I may have some spares lying about.

Hp Psc 1210 Check Print Cartridge Error

Z7_M0I02JG0KONJ30ACBBF8MM1084 hp-hero-support-search Actions ${title} Loading... Modern printer software uses memory like eating candy. Hp 1350 Printer Check Print Cartridge Error Insert a card that you know has data on it. Hp Psc 1315 Check Printer Cartridge Error The only 56 machine I know of currently available is the OfficeJet 5610.

If the product uses a power module with a detachable power cord, disconnect the cord from the power module. http://orgias.org/hp-psc/hp-psc-1350-ink-cartridge-error.html by Bert on Dec 2, 2004 at 8:30pm Add comment Please sign in to comment Please sign in to comment HP PSC - Printer / Scanner / Copier 1350 Buy discount ink Buy this printer More HP questions © Copyright 2011-2016, FixYourOwnPrinter.com, Inc. If the On/Resume light starts blinking, the tricolor cartridge (the cartridge on the left) is the problem cartridge. When the lights begin to blink, press and hold both the On/Resume button () and the Paper Size button at the same time. Hp Psc 1210 Troubleshooting

Other than "Don't turn the printer off", does anyone have any suggestions? The sequence must be completed within ten seconds. When the Check Paper and Check Print Cartridge lights begin to blink simultaneously, release both the Cancel button () and the On/Resume button (). this contact form Step 6: Replace the problem cartridge If the problem hasn't been solved by the steps above, either the printer or the problem cartridge is defective.

If the issue persists, continue to the next solution. Hp Psc 1350 Error Code E Privacy Policy Terms of Use Sign Up Login Add Question unknown asked Dec 2, 2004 at 8:06pm 0 HP PSC - Printer / Scanner / Copier 1350 hp psc 1350 The printer says it needs 128 mg of memory. With the power on, disconnect the power cord from the rear of the product.

Support Forum Join the conversation!

Press and release the Color Start Copy button. Wait until the On/Resume button () is steady. It seems stange because ive had absolutly no problems for 4 years that ive had this printer. Hp Psc 1350 Troubleshooting You can change this preference below.

Lower the paper tray, and if necessary, slide the paper width guide to its outermost position. If the message on the computer indicates a specific cartridge, that is the problem cartridge. i have long working hour's. http://orgias.org/hp-psc/hp-psc-1350-error-e.html Disconnect the USB cable from the rear of the product.

Bought NEW Office Max brand cartridges (both black & color). Issue: The Check Paper and Check Print Cartridge lights blink In this error condition, the following blinking lights pattern displays on the control panel: On/Resume light: On Check Paper light: Blinking Check Print Cartridge light: Blinking Black Start Copy light: On Color Start Copy light: On Figure : The Check Paper and Check Print Cartridge lights are blinking Cause The carriage is stalled or jammed. Reply 0 0 « Message Listing « Previous Topic Next Topic » Related Documents HP Printers - Using HP Diagnostic Tools for HP Printers in WindowsHP Printers - After Windows 10 Upgrade, Printer Does Not PrintHP Printers - Using Google Cloud Print with Your HP PrinterHP Printers - Printer is Offline (Windows)HP Printers - Resolving Printhead Problems and Ink System Failure Videos English Open Menu English Deutsch Español Français Português 中文 한국어 † The opinions expressed above are the personal opinions of the authors, not of HP. A-N arknorth, Aug 15, 2008 #5 KingPin1000 Thread Starter Joined: Mar 19, 2006 Messages: 166 If it is true about that ribbon having failed in some way....how could my printer go from printing a week earlier & i didnt use it after that...could this ribbon fail just from not using it for a week?

Then slide the cartridge out of the carriage. Open the cartridge access door. Figure : Load the alignment page Close the scanner lid, and then press the Scan button on the control panel. Anmelden Teilen Mehr Melden Möchtest du dieses Video melden?

If these steps resolved the issue, you do not need to continue troubleshooting. If you can pull it from the rear of the product or the tray, always try the rear first. An alignment page prints automatically.