Clean cotton swabs or any soft, lint-free material that will not stick to the cartridges (coffee filters work well). If the product successfully turns off, press the On/Resume button () to turn on the product, and then press the appropriate button(s) on the product again to perform the intended task. Try printing something from your computer.6. note: It might take a few minutes for the product to turn on. have a peek here
If it didnt..what would that mean? note: If the carriage does not move into the access area, turn the product off and then on again. If you do, and if the HP software is installed on the computer, you should have seen a message displayed on the computer. Press and hold the Cancel button ().
If the product successfully turns off, press the On/Resume button () to turn on the product, and then press the appropriate button(s) on the product again to perform the intended task. The following blinking lights pattern displays on the control panel: On/Resume light: Blinks fast for 3 seconds and then stays on Check Paper light: Off Check Print Cartridge light: Off Black Start Copy light: Blinking Color Start Copy light: Blinking Figure : The On/Resume light blinks fast for 3 seconds, and then remains on, and the Black Start Copy and Color Start Copy lights blink Cause The product is busy doing another task. The printer will not print.
I'm sure it's been posted in this forum already, but just a few simple things you could try first. Turn the printer off for a minute.Step 3Turn the HP printer on. I got another printer just like it and changed the whole print head over. Hp Psc 1210 Check Print Cartridge Error Reach inside the product through the cartridge access door, and then manually move the carriage.
by unknown on May 27, 2007 at 6:27am Add comment Please sign in to comment 0 I loaded a brand new HP print cartridge that I purchased at a reputable computer store. Hp Psc 1315 Check Printer Cartridge Error Thanks for your service. by unknown on Aug 28, 2007 at 6:34pm Add comment Please sign in to comment 0 All lights flashing typically means a fatal error. http://support.hp.com/us-en/document/c00094661 When only the On/Resume button () is blinking, release both buttons.
note: An E might also appear in the Copies display. Hp Psc 1350 Error Code E Locate the front panel overlay and peel off the paper backing to expose the adhesive as shown in the graphic below. Before saying goodbye to your 1350 do a reset. The presence of an E, however, does not affect the meaning of the blinking lights, and can be disregarded for troubleshooting purposes.
Last rights please. If this works then the issue is the black cartridge.The printer does not "know" that a cartridge is refilled, but it does do an electrical check to make sure the cartrdige is OK and will not damage the printer electronics. Hp 1350 Printer Check Print Cartridge Error Torn pieces of paper from a previous jam are stuck in the product. Hp Psc 1350 Troubleshooting The paper is jammed inside the HP product where you cannot see it.
Press and hold the Cancel button (), and then press the Start Copy Color button. This is particularly important on newer low cost (cheaply made) HP inkjet printers. Follow these steps to plug your product directly into a wall outlet. http://orgias.org/hp-psc/hp-psc-1350-error-e.html Open the scanner lid.
One last test, and it deals with your brother. Hp Psc 1210 Troubleshooting KingPin1000, Aug 16, 2008 #6 arknorth Joined: Oct 17, 2007 Messages: 1,099 Yes, the ribbon can fail while sitting - you've got to remember that they are ribbon wires - the same thing that computers use on older HDs, and they do tend to get a whole bunch of twisting and bending while in use. Before loading paper in the tray, hold the stack of paper, and then tap the bottom edge on a flat surface so that the stack is even on all sides.
Your reset trick worked fine. Open the cartridge access door. by Bert on Jan 2, 2005 at 8:42pm Add comment Please sign in to comment 0 The vertical streak is a puzzle. How To Reset Hp Psc 1410 Printer When the lights begin to blink, press and hold both the On/Resume button () and the Paper Size button at the same time.
Make sure that the length and width adjusters on the tray are correctly positioned, and then push the stack of paper forward until it stops in the tray. If the issue persists, continue to the next solution. Open then close the cartridge access door, as shown:Then press the On/Resume button, once, firmly. http://orgias.org/hp-psc/hp-psc-1350-ink-cartridge-error.html Yes, the money on the cartridges is out the window unless you can sell them on Craigslist or something.
I think the problem was a driver location issue and after plugging and unplugging it and shutting it off so many times, the computer finally "figured it out", I suppose. Do not overload the tray with paper. Step one: Download and then install the HP software Turn on the printer. thank's (bert)you are very helpful . - unknown 0 Under what circumstances do you get the streak, when printing from the computer or copying?
Reply 0 0 gizmo6 Student Posts: 1 Member Since: 08-03-2011 Message 4 of 18 (13,389 Views) Report Inappropriate Content Re: Sudden Print Cartridge Error For PSC 1315 Unsolvable! It still doesn't mean that the unit is a happy one. If the product operates normally, there is no need to continue troubleshooting.