Home > Hp Psc > Hp Psc 1315 Error

Hp Psc 1315 Error

Contents

In the program being printed from, click File, click Print, click Properties, and then click the Paper/Quality tab. Click OK, and then click OK again to print the document. If these steps resolved the issue, you do not need to continue troubleshooting. Figure : Remove scraps of paper Gently push the pins on the right end of the rear access door into the holes on the right side of the rear access area, and then snap the door firmly back into place. Check This Out

The paper-width guide is pressed against the paper stack too tightly. Solution two: Check the condition of the paper, and then reload it Paper feed issues might result from dusty, torn, wrinkled, wet, or folded paper in the tray. The product prints a self-test report. Reply 0 Re: I have a print cartridge error with my HP PSC 1315 all-in-one. 01-07-2013 03:04 AM Hi,If expired cartridges are present in printer, the printer will not be blocked but error message\light will be displayed to replace cartridge.If expired cartridges are replaced with new ones the issue should be fixed. http://h30434.www3.hp.com/t5/Inkjet-Printing/Sudden-Print-Cartridge-Error-For-PSC-1315-Unsolvable/td-p/277223

Hp Psc 1315 Check Printer Cartridge Error

It remains a mysterious singular occurrance. Right-click the following link, How to Buy HP, to buy a compatible power cord. While it is unplugged, clean the electrical contacts on the ink cartridges and their conjoining electrical contact within the printer. note: You need to use 10 to 25 sheets of paper only for purposes of these troubleshooting steps.

Solutions Solution one: Turn the All-in-One off and then on again Follow these steps to turn the product off and then on again. Examine the condition of the paper, and then replace any ripped, dusty, curled, wrinkled, or bent paper. If the issue persists, continue to the next solution. Hp Psc 1350 Troubleshooting The ink can dry and clog the nozzles if the cartridge is outside of the printer for too long.

REFERRING TO YOUR INSTRUCTIONS, I HAVE A QUESTION: Disconnect the Universal Serial Bus (USB) cable from the back of the product, but leave the product turned on Open the cover of the product and remove the print cartridges Close the cover and wait... Sprache: Deutsch Herkunft der Inhalte: Deutschland Eingeschränkter Modus: Aus Verlauf Hilfe Wird geladen... Z7_3054ICK0KGTE30AQO5O3KA30H5 hp-country-locator-portlet Actions ${title} Loading... have a peek at these guys Solution five: Check for carriage obstructions Follow these steps to make sure that the carriage can move freely.

Solution two: Cancel and then retry the task Follow these steps to cancel and then retry the current task. Hp Psc 1210 Troubleshooting Figure : Open the cartridge access door Hold the cartridge on its sides, and then slide the cartridge forward into its slot at a slightly upward angle. Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎06-08-2010 03:08 PM I've had no problems with my PSC 1315 until about a week ago. Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎06-07-2012 07:56 PM See the troubleshooting steps in this page.

Hp 1350 Printer Check Print Cartridge Error

Be careful not to push the paper in too far, which can cause paper jams. Figure : Removing the problem cartridge If there is tape on the cartridge, remove it. Hp Psc 1315 Check Printer Cartridge Error If these steps resolved the issue, you do not need to continue troubleshooting. How To Reset Hp Psc 1410 Printer Disconnect the USB cable from the rear of the product.

Reply 0 0 millibob Top Student Posts: 3 Member Since: ‎09-04-2013 Message 8 of 8 (4,131 Views) Report Inappropriate Content Re: hp psc1315 suddenly gives me a "Check Print Cartridge" error. his comment is here The sequence must be completed within ten seconds. Torn, wrinkled, or damp paper loaded in the paper tray. Please mark the post that solves your problem as Accepted Solution. Hp Psc 1210 Check Print Cartridge Error

caution: Do not force the paper to move too far forward in the tray. First Time Here? Load plain, white paper into the paper tray. http://orgias.org/hp-psc/hp-psc-1315-fatal-error.html The onlychange from the pre-problem erais that changing a cartridge does not automatically trigger an alignment sequence.

If you haven't tried cartridge replacement, replace the problem cartridge now. Hp Psc 1410 Check Print Cartridge Flashing Solution four: Service the All-in-One If you have completed all the steps and are still experiencing a problem, continue to the Service the All-in-One section at the end of this document. Privacy Policy © Copyright 2016 HP Development Company, L.P.

If these steps resolved the issue, you do not need to continue troubleshooting.

Step one: Disconnect and then reconnect the USB cable Disconnect the USB cable from the rear of the product. Figure : Insert the cartridge Firmly push the cartridge in until it snaps into place. Step one: Make sure that the carriage can move freely Press the On/Resume button () to turn on the product. Hp Psc 1350 Manual Try the intended task again.

If the self-test report does not print, continue with the next solution. Figure : Disconnect the power cord Unplug the power cord from the wall outlet. Press and release the Paper Type button. navigate here Diese Funktion ist zurzeit nicht verfügbar.

Press the On/Resume button () to turn on the product. Step two: Print a self-test report Print a self-test report. Make sure that the rollers are not missing, that they turn easily, and that they are springy when you press them. Solutions Solution one: Wait for the All-in-One to complete the job Allow the product to complete the current job.

Click here for instructions to download and install the HP Print and Scan Doctor. Press and then quickly release the On/Resume button () to start a power on/off cycle. When the lights begin to blink, press and hold both the On/Resume button () and the Paper Size button at the same time. Reconnect the power cord to the rear of the product.

If these steps resolved the issue, you do not need to continue troubleshooting. Followed HP trouble shooting guide. Open the scanner lid. Do not mix different types, weights, or sizes of paper.

If the issue persists, continue to the next solution. Follow these steps to clear any jammed paper. Unplug the printer.