When the issue is resolved, you can resume loading paper according to the paper tray capacity specifications for your product. If these steps resolved the issue, you do not need to continue troubleshooting. Figure : Rotate and clean the paper feed rollers Locate the pick roller on the left side of the product below and behind the paper feed roller. Right-click the following link, How to Buy HP, to buy a compatible power cord. http://orgias.org/hp-psc/hp-psc-1315-error-code-e.html
Reply 0 0 « Message Listing « Previous Topic Next Topic » Related Documents HP Printers - Using HP Diagnostic Tools for HP Printers in WindowsHP Printers - After Windows 10 Upgrade, Printer Does Not PrintHP Printers - Using Google Cloud Print with Your HP PrinterHP Printers - Printer is Offline (Windows)HP Printers - Resolving Printhead Problems and Ink System Failure Videos English Open Menu English Deutsch Español Français Português 中文 한국어 † The opinions expressed above are the personal opinions of the authors, not of HP. Unplug the power cord from the wall outlet. Connect the alternate power cord to the rear of the product.
Then slide the cartridge out of the carriage. With the product turned on, disconnect the power cord from the rear of the product. Check the paper feed rollers on the rear access door to make sure that they are clean, free of paper bits, and rotate freely. Hp Psc 1350 Manual Plug the alternate power cord into the wall outlet.
If you have a defective cartridge or printhead, it might be under warranty. Hp Psc 1210 Check Print Cartridge Error The sequence must be completed within ten seconds. note: If the page displays in the wrong country/region or language, click the Region - Language link in the upper right corner of your browser. http://support.hp.com/us-en/document/c01577374 Do not push the guide in so tightly that it binds against the paper.
Solution four: Service the All-in-One If you have completed all the steps and are still experiencing a problem, continue to the Service the All-in-One section at the end of this document. How To Reset Hp Psc 1410 Printer Try the intended task again. The product aligns the cartridges. Figure : Press the Scan button to begin the alignment The alignment is complete when the On/Resume light () stops blinking. First Time Here?
Reconnect the USB cable to the rear of the product.
Press the tab on the left side of the rear access door, and then pull the door outward to remove it. Hp 1350 Printer Check Print Cartridge Error Step two: Print a self-test report Print a self-test report. Hp Psc 1315 Check Printer Cartridge Error The product prints a self-test report.
When the lights begin to blink, press and hold both the On/Resume button () and the Paper Size button at the same time. navigate here Press the On/Resume button () to turn on the product. Figure : Remove the rear access door Press in the tab Pull out the door Lightly dampen a clean, lint-free cloth with bottled or distilled water, and then squeeze any excess liquid from the cloth. Video should be smaller than 600mb/5 minutes Photo should be smaller than 5mb Video should be smaller than 600mb/5 minutesPhoto should be smaller than 5mb Answer Questions What is best printer hp4729 o epson L375? Hp Psc 1210 Troubleshooting
Follow these steps to perform a partial reset of the product. Reconnect the power cord to the rear of the product. After you find the pattern that matches your blinking lights pattern, try each solution in the order presented until you resolve the issue. Check This Out Step one: Remove any loose paper Remove any loose sheets of paper from the input tray and the output tray.
Yes No Sorry, something has gone wrong. Hp Psc 1210 Reset Figure : Disconnect the power cord Wait 15 seconds. Try the intended task again.
Reconnect the power cord to the rear of the product. If the issue persists, continue to the next solution. You might also experience the following symptoms: The product will not print. Hp Psc 1350 Troubleshooting Issue: The On/Resume and Black Start Copy lights blink In this normal condition, the following blinking lights pattern displays on the control panel: On/Resume light: Blinking Check Paper light: Off Check Print Cartridge light: Off Black Start Copy light: Blinking Color Start Copy light: On Figure : The On/Resume and Black Start Copy lights are blinking Cause The product is busy processing a black-and-white print job.
note: You might need a flashlight to illuminate areas for proper viewing. While holding the Cancel button (), press and hold the On/Resume button (). See the section on how to use these solutions at the beginning of this document. this contact form Figure : Install the front panel overlay Figure : Correctly installed front panel overlay Reconnect the power cord to the rear of the product.
Anyways if it printed in color, shouldn't it be an isolated problem with my black ink cartridge? Thank you! Register · Log In HP Support Forum Home > Printers > Inkjet > Sudden Print Cartridge Error For PSC 1315 Unsolvable! If you see the error "Print Cartridge Problem" try this: 1. The cartridge will shift and break its' connection.
Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content 01-29-2012 06:05 PM Has anyone figured this out? You can only upload files of type PNG, JPG, or JPEG. Press in the tab on the left side of the door, and then pull the door away from the product to remove it. Wait 15 seconds.
When I have both Ink cartridges in, I get the check print cartridge error pop up. Step one: Check the condition of the paper Remove the stack of paper from the tray. Disconnect the product cord from any power strip or surge suppressor, and then plug it directly into a three-prong wall outlet. Press and release the Color Start Copy button.
Step one: Replace defective cartridge This video shows how to replace the ink cartridges Click here to see this video in full screen on YouTube. Disconnect the USB cable from the rear of the product. Load plain, white paper into the paper tray. Try the intended task again.
Press and then quickly release the On/Resume button () to start a power on/off cycle. Press the Cancel button () on the control panel. You might look atthe "Check Print Cartridge light is blinking" about half way downin the document link below:http://support.hp.com/us-en/document/c01578337If those don't work, you might tryleaving the printer in turned on status, then unplug from the power source (back of printer or wall), wait 60 seconds, plug the power back in (if printer doesn't turn on automatically, press power button to turn on). Doing so can cause bad electrical connections, clogged ink nozzles, or poor print quality.