If the front panel overlay is already installed, and your printer has been working for some time, do not attempt to reinstall the overlay. Solution four: Remove and reinstall the cartridges Follow these steps to make sure that both cartridges are installed and seated correctly. Press the On/Resume button () to turn on the product. note: You might need a flashlight to illuminate areas for proper viewing. Check This Out
Working... Figure : Open the cartridge access door Carefully remove any jammed paper from the front of the product. Close the cartridge access door. And if I do buy a new one to fix the problem and that doesnt work I would have wasted a lot of money on ink. other
Figure : Lift the scanner lid Place the alignment page face down on the scanner glass in the lower-left corner. Figure : Load the alignment page Close the scanner lid, and then press the Scan button on the control panel. If the issue persists, continue to the next solution. I did a reset. Figure : Reinsert the cartridge Firmly push the cartridge in until it snaps into place.
Respond to this 1 There is no service manual available. Press in the tab on the left side of the door, and then pull the door away from the product to remove it. Follow these steps to perform a partial reset of the product. Hp Psc 1350 Troubleshooting Transcript The interactive transcript could not be loaded.
note: If the carriage does not move into the access area, turn the product off and then on again. Hp Psc 1350 Check Print Cartridge Insert the paper into the paper tray print side down until it stops. Disconnect the power cord from the rear of the product. Homepage Compare the paper size and type settings on the Paper/Quality tab to the paper loaded in the paper tray.
Load plain, white paper into the paper tray. How To Reset Hp Psc 1410 Printer If these steps resolved the issue, you do not need to continue troubleshooting. It might take several tries to complete the sequence within ten seconds. This is annoying as hell.
An alignment page prints automatically. http://h30434.www3.hp.com/t5/Inkjet-Printing/paper-jam-error-message-hp-psc-1210/td-p/1844979 note: If the carriage does not move into the access area, turn the product off and then on again. Hp Psc 1210 Check Print Cartridge Error Wait until the On/Resume button () is steady. Hp Psc 1210 Troubleshooting Solution nine: Service the All-in-One If you have completed all the steps and are still experiencing a problem, continue to the Service the All-in-One section at the end of this document.
Figure : Load paper in the paper tray Adjust the paper width guide inward until it rests against the side of the paper. his comment is here note: If the carriage does not move into the access area, turn the product off and then on again. With the power on, disconnect the power cord from the rear of the product. Solutions Copy, Scan, or Print Press the appropriate button(s) on the product to perform the intended task. Hp Psc 1315 Check Printer Cartridge Error
Solutions Solution one: Turn on the All-in-One Press the On/Resume button () to turn on the product. If you have cleaned the cartridge and carriage electrical contacts with a cotton swab and alcohol, and are absolutely sure that the cartridges you've tried are good, do what HP calls a partial reset. "Disconnect and then reconnect the power cord. Figure : Open the cartridge access door Press lightly on the top of the cartridge that you are removing to release it from its slot. this contact form Remove the rear access door.
Disconnect the power cord from the rear of the product. Hp Psc 1410 Check Print Cartridge Flashing Solution four: Service the All-in-One If you have completed all the steps and are still experiencing a problem, continue to the Service the All-in-One section at the end of this document. All other indicators are normal except that the 'copy count' indicator show 'E' (indicating no cartridges are loaded at all).
Figure : Secure the USB cable note: Make sure that the USB cable is connected correctly. Solutions Solution one: Wait for the All-in-One to complete the job Allow the product to complete the job. Plug the power cord back into the wall outlet. Hp Psc 1350 Manual If the product does not complete the cartridge alignment, it will print an alignment page every time you turn on the product.
Press the Cancel button () on the control panel. If the issue persists, continue to the next solution. Place your index finger in the finger slot on the paper tray at the front of the product. navigate here To reinsert, hold the cartridge by its sides, and then slide the cartridge forward into its slot at a slightly upward angle.
The icon on the USB cable () generally faces up when the cable is connected correctly. If you cannot cancel the task, press and hold the On/Resume button () for three seconds to turn off the product. Step two: Align the cartridges Follow these steps to align the cartridges. Trying to clear jammed paper from the front of the product can damage the print mechanism.
This video shows how to clear a paper jam from the All-in-One Click here to see this video in full screen on YouTube. On some models, the language and country/region settings also reset.