Home > Hp Psc > Hp Psc 1210 Error Reset

Hp Psc 1210 Error Reset

Contents

ANYONE TO PLEASE HELP ME,I'VE BEEN AT IT FOR 3 DAYS STRAIGHT!!!ANY HELP IS GREATLY APPRIETIATED,THANX......! Figure : Disconnect the power cord Wait 15 seconds. In the program being printed from, click File, click Print, click Properties, and then click the Paper/Quality tab. Wait until the On/Resume button () is steady. have a peek here

Figure : Remove the protective tape using the pull tab caution: Do not touch the copper-colored electrical contacts or the ink nozzles on the cartridge. If the product does not turn on automatically, press the On/Resume button () to turn the product back on. note: Forcing the paper too far into the product might cause multiple sheets of paper to be fed through the print mechanism, or cause a paper jam. It might take several tries to complete the sequence within ten seconds. browse this site

Hp 1350 Printer Check Print Cartridge Error

Press and release the Color Start Copy button. Solutions Solution one: Open the paper tray Follow these steps to open the paper tray. If the product does not complete the cartridge alignment, it will print an alignment page every time you turn it on. The reset is now complete.

also, the cartridge holder is going to the extreme right instead of staying left like usual...I have not changed the cartridges because I dont really fell like buying cartridges if the problem is the printer and that I have to get rid of it... Figure : Slide out the paper width guide and fold out the paper tray extender Tap the stack on a flat surface to align the edges of the paper. Step two: Print a self-test report Follow these steps to print a self-test report. Hp Psc 1350 Manual Figure : Open the cartridge access door Without turning off the product, disconnect the power cord from the rear of the product.

Press and hold the Cancel button (), and then press the Start Copy Color button. Hp Psc 1210 Check Print Cartridge Error note: The black cartridge belongs in the slot on the right. You can utilize this website to learn how to contact HP appropriately, based on your region: Contact HP Worldwide.Thank you for contacting the HP Forums. If the issue persists, continue to the next solution.

Copy feature doesnt have any delay. How To Reset Hp Psc 1410 Printer Wait until the On/Resume button () is steady. Press and hold the Cancel button (), and then press the Start Copy Color button. The sequence must be completed within ten seconds.

Hp Psc 1210 Check Print Cartridge Error

Press the Scan button to try the scan job again. http://www.fixyourownprinter.com/posts/21842 If the alignment page does not print automatically, follow these steps to print one manually: If the product is off, press the On/Resume button () to turn on the product. Hp 1350 Printer Check Print Cartridge Error If the product successfully turns off, press the On/Resume button () to turn on the product, and then press the appropriate button(s) on the product again to perform the intended task. Hp Psc 1210 Troubleshooting Do not use paper that is bent, torn, dusty, damp, wrinkled, curled, or paper that does not lie flat.

Load plain, white paper into the paper tray. navigate here by saramara on Feb 8, 2006 at 3:20pm Add comment Please sign in to comment My roommate had the same problem with the same printer. If the issue persists, continue to the next solution. Figure : Disconnect the USB cable from the rear of the product Disconnect the USB cable from the rear of the computer. Hp Psc 1315 Check Printer Cartridge Error

The carriage is slamming back and forth on the rail. If the LED does not light up, contact HP to replace the power module. If the product does not turn on, follow the same steps and try a different wall outlet. Check This Out Issue: The On/Resume light blinks In this normal condition, the following blinking lights pattern displays on the control panel: On/Resume light: Blinking Check Paper light: Off Check Print Cartridge light: Off Black Start Copy light: On Color Start Copy light: On Figure : The On/Resume light is blinking Cause The product is busy copying, scanning, printing, or performing a photo or maintenance job, such as alignment.

LMAOThank you HP! Hp Psc 1350 Troubleshooting It's not like I have a habit of meddling around in it or throwing it around (although the temptation to do so if often dangerous.) At this point, if I thought taking it apart and messing with it would do any good, I would probably give it a shot. If the issue persists, continue to the next solution.

Look inside the product to see where the carriage is stuck, and then check for any torn paper or objects that might be restricting the carriage.

Press the On/Resume button () to clear the error, and then try the intended task again. If these steps resolved the issue, you do not need to continue troubleshooting. note: You might need a flashlight to illuminate areas for proper viewing. Hp Psc 1410 Check Print Cartridge Flashing If the settings in the Paper/Quality tab are incorrect, change the settings to match the paper loaded in the paper tray.

I double clicked on the 'hp psc 1200 series' icon. Figure : Gently remove the jammed paper caution: Use a flashlight to thoroughly check the rollers and wheels for torn pieces of paper that might remain inside the product. h10025.www1.hp.com by Bert on Dec 31, 2004 at 1:07pm Add comment Please sign in to comment 0 I am having the same problem with a 1210. this contact form Any ideas?

But then it copys double. I can only printing 2-3 label and the next one will miss align to the circle of the CD/DVD label. Solution five: Test the power with a compatible power cord from a different All-in-One If you have another available power cord that is compatible with the product, use the alternate cord to test the power. Presumably I need to get the top off the printer to get at the encoder strip?

Press and release the Cancel button () again. Please click “Accept as Solution " if you feel my post solved your issue, it will help others find the solution.Click the “Kudos, Thumbs Up" on the right to say “Thanks" for helping!Jamieson I work on behalf of HP"Remember, I'm pulling for you, we're all in this together!" - Red Green. These are the steps: * Set your computer system date to a date before the expiry of the ink cartridges. * Start the following program: C:\Programs\Hewlett-Packard\Digital Imaging\bin\hposvc08.exe * Use the password "Homer" Choose the reset directory Follow Us Quick Help My Account Return a Product Shipping Info Log In Cart Customer Service Contact Us Payment Options School & Goverment Agencies PO´s Order Status Privacy and Policies Our Company About Us Our Guidelines Certifications Ink and Printing Tips We Proudly Accept Visa Discover MasterCard American Express Pay Pal All brand names and trademarks are the properties of their respective owners and are referred to here for descriptive purposes only.