Close the cartridge access door by pressing firmly on the door until it snaps into place. This video shows how to print a test page Click here to see this video in full screen on YouTube. Open the scanner lid. MikeH posted Oct 16, 2016 at 11:56 PM WCG Stats Sunday 16 October 2016 WCG Stats posted Oct 16, 2016 at 8:01 AM Happy Birthday Captain Zed! Check This Out
Solution two: Make sure that the front panel overlay is installed correctly If the front panel overlay, or bezel, is incorrectly installed, the product may indicate a false carriage stall error condition. by unknown on Jan 9, 2006 at 9:01pm Add comment Please sign in to comment Please sign in to comment HP PSC - Printer / Scanner / Copier 1210 Buy discount ink Buy this printer More HP questions © Copyright 2011-2016, FixYourOwnPrinter.com, Inc. On some models, the language and country/region settings also reset. Step three: Replace the USB cable Securely connect an alternate USB cable to the rear of the product.
None of the suggested troubleshooting techniques in the user ref manual do any good. If the product operates normally, allow the product to complete the job. Press and release the Color Start Copy button. If the issue persists, continue to the next solution.
If you think you have received a fake HP Support message, please report it to us by clicking on the blue “Report Inappropriate Content” button above the message. If you would like to scan the result you may email it to me at and I may be able to tell something. Respond to this 1 There is no service manual available. How To Reset Hp Psc 1410 Printer The tray contains more than one type of paper.
If after trying the task, a blinking light or combination of blinking lights displays on the product control panel, find the pattern you are experiencing in this document, and then follow the steps to resolve the issue. Hp Psc 1210 Troubleshooting Close the cartridge access door. Press in the tab on the left side of the door, and then pull the door away from the product to remove it. this Try the intended task again.
Open the cartridge access door. Hp Psc 1350 Troubleshooting Thanks! After you find the pattern that matches your blinking lights pattern, try each solution in the order presented until you resolve the issue. If the product is unresponsive for more than 60 seconds, continue to the next solution.
Step one: Perform a power reset Press the On/Resume button () to turn on the product. Step 3: Remove and reseat the problem cartridge If the problem still occurs, the electrical contact between the cartridges and the printer might be bad. Hp Psc 1210 Check Print Cartridge Error When the Check Paper and Check Print Cartridge lights begin to blink simultaneously, release both the Cancel button () and the On/Resume button (). Hp Psc 1350 Check Print Cartridge I've tried several different ink carts to no avail.
Remove all ink cartridges.. http://orgias.org/hp-psc/hp-psc-1210-error-codes.html Hoping to avoid buying new cartridges unless absolutely necessary. I have cleaned the cartridges and followed that guide, yet nothing works. Press the On/Resume button () once slowly to turn on the product. Hp Psc 1315 Check Printer Cartridge Error
note: An E might also appear in the Copies display. While holding the Cancel button (), press and hold the On/Resume button (). Securely reconnect the USB cable to the rear of the computer. this contact form If these steps resolved the issue, you do not need to continue troubleshooting.
If these steps resolved the issue, you do not need to continue troubleshooting. Hp Psc 1210 Reset Figure : Removing the problem cartridge If there is tape on the cartridge, remove it. Log into JustAnswer.com, then on the Top right, click on my questionsThen, click the "reply to expert" next to my face..
Removing and reseating the cartridges might help.Open the cartridge access door and wait a moment for the cartridges to come to the center.Press down on the end of the problem cartridge to snap it out of the carriage.Figure 3: Removing the problem cartridgeIf there is tape on the cartridge, remove it. Figure : Press and then quickly release the On/Resume button If you press and hold the On/Resume button too long, the product might turn on and then off without restarting. If the product completes the job normally, there is no need to continue troubleshooting. Hp Psc 1410 Check Print Cartridge Flashing caution: Do not remove jammed paper at this stage.
Pulling paper from inside the front cover can cause mechanical damage to the product. About 5 years 10/17/2016 10/17/2016 Viet - Printer Tech Cannot scan from hp 8600 printer to computer, hp officejet 10/17/2016 10/17/2016 Viet - Printer Tech FOR VIET ONLY. If the product successfully turns off, press the On/Resume button () to turn on the product, and then press the appropriate button(s) on the product again to perform the intended task. navigate here Wait until the On/Resume button () is steady.
Please make sure to click one of the smileys to rate this answer as successful, and then accept the answer. No, create an account now. If you cannot cancel the task, press and hold the On/Resume button () for three seconds to turn off the product. Damaged or dirty paper rollers.
Gently lower the tray until it is horizontal and stops.