Home > Hp Officejet > Hp Officejet Pro K5400 Ky Error

Hp Officejet Pro K5400 Ky Error

Contents

You can't post answers that contain an email address. Contributor 2 Answers Re: My KY yellow light is blinking. If both Printhead lights are blinking, repeat steps 1 through 14 to remove and reinsert the other printhead. Info.When I installed it, the driver was - 2417307. Check This Out

Get a Professional Answer Via email, text message, or notification as you wait on our site.Ask follow up questions if you need to. 100% Satisfaction Guarantee Rate the answer you receive. Figure 75: Insert the cartridge and close the cartridge door Issue: The Power light blinks and one or more Print Cartridge lights are on In this error condition, the following light pattern displays on the control panel: Print Cartridge lights: On Printhead lights: Off Cancel button: Off Resume light: Off Power light: Blinking Figure 76: The Power light blinks and one or more Print Cartridge lights are on Cause A cartridge is out of ink. Solution two: Remove and reinsert the printhead Improper printhead placement or installation might cause a printhead error. Typical HP.

Hp Officejet Pro K5400 Troubleshooting

Thanks! NOTE: The product might go through a warm-up period of up to two minutes. Latest 3. Any suggestions?The other thing, it will not print a test page either.

When I returned the blue ink cartridge indicator light was blinking and... Figure 68: Open the cartridge door Remove the cartridge indicated by the blinking light on the control panel. HP Officejet 6500 Wireless... 10 Answers No scan options say refer to device documention to trouble shoot HP Officejet 5610 All-In-One... 38 Answers HP Officejet 5610 All-in-One scanner will not work HP Officejet 5610 All-In-One... 9 Answers Printer drivers HP 4355 HP Officejet 4355 All-In-One... Align the cartridge with its color-coded slot, and then insert it into the slot.

If the error message no longer displays on the computer, you do not need to continue troubleshooting. Hp Officejet Pro K5400 Manual Press down firmly on the cartridge until it clicks into place, and then close the cartridge door. After the first time that I had a jam on my printer (after about 8 months of use) the ky light began blinking despite clearing the jam.It's not good when the printer blinks but won't work. great post to read If the issue persists, continue to the next solution.

Learn more You're viewing YouTube in Russian. It's a shot in the dark but may be relevant.2. PORGED YOUR PRINTER TO TAKE OUT THE BUBBLE Aug 18, 2009 | HP Officejet Pro K5400 All-In-One InkJet... 2 Answers Help with my k5400 It's possible you have one of the following problems: Printhead is faulty The printhead has expired (HP printheads have an expiry date which is written into the chip)In both of these cases contact HP support to request a warranty replacement (but try the ideas below first obviously :)) The printhead hasn't been inserted properly The chip contacts are dirty or soiled in some wayFor these last two, try removing the printhead, cleaning the chip carefully with a cotton bud and then replacing carefully.It's also entirely possible that you've been sold a lemon in which case you need to call the store you bought the printer from and get them to troubleshoot the issue with you and/or replace it/refund your money.Hope that helps. Share on Facebook Share on Twitter Share on Google+ Share on Pinterest Share by Email × Question about HP Officejet Pro K5400 All-In-One InkJet Printer 2 Answers My KY yellow light is blinking.

Hp Officejet Pro K5400 Manual

Solution one: Check for missing cartridges Follow these steps to check for missing cartridges, and then insert cartridges if necessary. http://www.fixya.com/support/t1709031-ky_yellow_light_blinking Release the Resume button, and then wait until the carriage is idle and silent. Hp Officejet Pro K5400 Troubleshooting Lift the printhead latch. Reconnect the power cord to the rear of the product.

Ask Anonymously Popular Questions 31 Answers No HP devices detected. his comment is here Try the troubleshooting steps shown here. Solution Follow these steps to replace the cartridge indicated by the blinking light on the product control panel. Do not mistake a locked carriage for a stuck carriage.

If the issue persists, continue to the next solution. Turned the printer off and on to reset. Clean the contacts on the back of the ink cartridge and also the contacts in the K5400 printer. http://orgias.org/hp-officejet/hp-officejet-pro-k5400-error-ky.html Figure 20: Lift the output tray Pull the paper length guide to its outermost position.

WARNING: You must disconnect the power cord to move the carriage mechanism by hand without the risk of electrical shock. Disconnect the USB cable from the product, and then disconnect it from the computer.3. The lights also indicate when a non-HP print cartridge is installed (the light blinks and the Attention light is on).

Important: Before you begin, make sure that the cartridges are compatible with your product.

Press the Power button to turn on the product. Printhead Error on 30-day old HP OfficeJet Pro 6830. Help this question get an answer by entering the correct category or product below. Use the following steps to replace your expired cartridge.

The Devices and Printers window opens. Figure 4: Paper path top zone Reattach the rear access door. Option two: Clear the jam from the duplexer Disconnect the USB cable or the Ethernet cable from the rear of the product, depending on your connection type. navigate here Info.