Home > Hp Officejet > Hp Officejet 7410 Paper Jam Error

Hp Officejet 7410 Paper Jam Error


i have resorted to just writing squiggly lines on blank printer paper to keep it from ruining important stuff after the first two tries. If so, where and how much? There is no paper anywhere in the system. Solution two: Make sure that the carriage can move freely Use the following steps to make sure that the carriage moves freely. Source

Step one: Remove loose paper from the tray Remove any loose sheets of paper from the input tray and the output tray. If the issue persists, continue with the next solution. Watch QueueQueueWatch QueueQueue Remove allDisconnect Loading... Reply 0 0 chrystinp Tutor Posts: 21 Member Since: ‎12-10-2009 Message 8 of 15 (17,642 Views) Report Inappropriate Content Re: 7410 printer carriage jam error message HELP Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎12-10-2009 10:06 AM This thread was a real life-saver for me today.

Hp 7310 Carriage Jam Fix

The guy at HP assured me it would come with no instructions. The only way to print now is to unplug it and completely reset it each time.Help?Ben by unknown on Nov 27, 2011 at 5:15pm Add comment Please sign in to comment 0 I have a 7210 and the grinding noise only occurs when trying to fax. If for some bizarre reason they get dust in between the slits that block the sensor, then just blow the strip with some canned air. It's white plastic with thin wires running down it.

Press 2, and then press 5. Z7_3054ICK0KGTE30AQO5O3KA3015 hp-online-communities-portlet Actions ${title} Loading... justprintingaround 62,947 views 4:25 HP Officejet Pro L7780 - Duration: 5:28. If it does, allow it to move to that position.

See the steps on how to print a self-test report at the top of this document. Hp Printer Paper Jam Error But No Paper Jam by unknown on Jun 1, 2008 at 7:14am Add comment Please sign in to comment 0 Same message Carraige jam.I can not get the print cartridges out because a bar poped up in front of the cartridges. Loading... http://h30434.www3.hp.com/t5/Inkjet-Printing/7410-printer-carriage-jam-error-message-HELP/td-p/38688 The tray is too full.

by Anonymous on Sep 8, 2008 at 10:07am Add comment Please sign in to comment 0 @ Anonymous, posted 10/28/08 4:44 PM.Is your problem as described above? How do I take this thing apart to check if there is something obvious?Thanks! This unlocks the cartridge cradle and it will start to move to the left.- Immediately pull the small plug from the back of the machine to avoid risk of electric shock. Figure : Paper rollers on the duplexer Use a flashlight to thoroughly check for torn pieces of paper that might remain inside the printer.

Hp Printer Paper Jam Error But No Paper Jam

Step one: Perform a power reset Press the Power button () to turn on the product. directory Pull the door away from the product to remove it. Hp 7310 Carriage Jam Fix I wasn't sure if that was the problem so I've tried all the other self-help steps including the ones youreferenced about cleaning the tape and the bent bias spring (they are not bent). Hp Officejet 7310 All-in-one Printer Troubleshooting About Press Copyright Creators Advertise Developers +YouTube Terms Privacy Policy & Safety Send feedback Try something new!

HP Printer Support 59,325 views 11:51 How to Refill Inkjet Cartridges - Duration: 12:39. this contact form How to separate the scanner unit. Does any one have removal/replacement instructions. Loading... Staples

I guess I am ham fisted so maybe I broke it?The ink cartridge cage wire is adrift, and the ribbon behind it punctured.Had a go at fixing the popping out retaining spring / thing, and succeeded in that by strapping to the ink cartridge two pieces of an old plastic credit/ bank card- to get enough thickness- cut to fit on the side where the spring is popping out. by Bert on Aug 14, 2007 at 1:35pm Add comment Please sign in to comment 0 I need a new carriage with wiring for a 7310. 1) Where is a good place to by HP Parts?2) Where can I find a diagram or service instructions? How to print a self-test report Load plain white paper in the input tray. http://orgias.org/hp-officejet/hp-officejet-7410-error-0x07a74dd6.html Figure : Remove the rear access door To remove the duplexer: Press in the buttons on the sides of the duplexer, and then pull the duplexer toward you.

I cannot just go buy another printer.This is the 7310xiThank you! If these steps resolved the issue, and the test page prints, there is no need to continue troubleshooting. Gently pull the paper out of the rollers inside the printer.

Only way I've found to fix this problem.

Reconnect the power cord to the rear of the printer, and then reconnect the USB or Ethernet cable. This could damage the print mechanism. Press the cloth against the rollers and rotate them upwards with your fingers. Solution five: Service the All-in-One Contacting HP for service in all countries/regions except Asia Pacific.

now when i try 2 print from my computer, it tells me that it cant find a printer. Working... by RBGBRIG on Nov 25, 2007 at 1:53pm Add comment Please sign in to comment http://www.fixyourownprinter.com/forums/inkjet/50913 - moe When that spring breaks, it puts a hole in the ribbon cable breaking at least one connection for that cartridge. Check This Out Skip navigation UploadSign inSearch Loading...

Push the duplexer forward until it snaps into place. Try to print a self-test report. now when i try 2 print from my computer, it tells me that it cant find a printer. Step one: Clear any loose paper from the paper tray If any loose paper is accessible from the paper tray, follow these steps to remove the paper.

Paper was added to a stack already in the tray while the HP product was printing. by RC63 on May 23, 2011 at 8:48pm Add comment Please sign in to comment 0 Did you try a "hard reset"? I even uninstalled and reinstalled the printer. See the steps on how to print a self-test report at the top of this document.

Loading... This does not solve my problem. Solution three: Clean the rollers and the rear access door Dust, paper fiber, and other debris might accumulate on the paper feed rollers and cause paper jams and paper feed issues. This provides easy access to the rollers and separator pad.

Figure : Lift the ADF cover ADF cover Rollers Separator pad Lightly dampen a clean, lint-free cloth with bottled or distilled water, and then squeeze any excess liquid from the cloth. If you see jammed paper, gently pull it out. Pulling paper from inside the front cover can cause mechanical damage to the product. Loading...

In this case, thescanner head made it half-way back, and then the grinding noisekicked in.2. IMPORTANT! Press the Power button () to turn off the product.