Home > Fax Error > Hp Officejet 5610 Error 344

Hp Officejet 5610 Error 344

Contents

Disable ECM, and then try to receive the fax again. 247 248 249 ECM 250 ECM 251 ECM The remote machine is locked. Press the Down arrow ( ) ... Try sending at a lower transmission speed. 356 357 358 359 361 362 ECM 363 ECM 364 ECM 365 ECM 366 ECM The remote user pressed the Stop key, causing the session to be terminated. Change transmit rate to ... http://orgias.org/fax-error/hp-officejet-5610-fax-error-344.html

Also, the transmission speeds over digital lines is much faster than analog. Contact the sender to make sure a document is ready and correctly loaded in the sending fax machine. There might be no solution because the remote machine could be defective. 381 ECM The remote machine failed to respond to a fax command from the local machine because the connection was interrupted. It also will not send more then 6 pages.

Fax Error 358

Turns out water had gotten into the phone line out along the street, just enough that it would test fine from the company office, but not good enough to fax. Make sure paper is loaded correctly, paper is not jammed within the machine, and any other system errors have been cleared. 232 233 234 235 ECM 236 ECM 237 A communication failure occurred between the two machines. Please advise.

Configure the remote machine for document reception by clearing any paper jams, loading sufficient paper, and clearing any other error messages. X-23I work on behalf of HPPlease click "Accept as Solution" if you feel my post solved your issue, it will help others find the solution.Click the "Kudos, Thumbs Up" on the right to say "Thanks" for helping! Reduce or enlarge the page size setting on the local machine to a size supported by the remote machine. 319 The local machine attempted to initiate a binary file transfer (BFT), but detected that the remote machine does not support this mode of operation. Hp Fax Error 322 These errors can occur if the phone lines in the area to be faxed are old or there is noise (static on the phone line).

Set the host machine to receive at a slower transmission speed. Hp Officejet Pro 8600 Fax Error 344 The remote user pressed the Stop key while the reception was in progress. Specialized programs are also available to diagnose system memory issues. https://h30434.www3.hp.com/t5/LaserJet-Printing/Error-344-when-faxing-with-HP-8600-All-tests-show-quot-pass/td-p/1765169 Everything You Should Know about It.Getting Mysterious Internet Traffic ?

One of the few exceptions to this would occur if the remote machine was configured to poll transmit a document, but was unable to receive. Hp Fax Error 345 Confirm that the local user really wants to attempt a poll reception. This error code has to do with a communication issue on the phone line. Contact the remote caller and have the fax sent again. 222 The local machine answered a call, but is unable to detect the presence of a calling fax machine.

Hp Officejet Pro 8600 Fax Error 344

This situation is usually due to extremely poor line conditions. http://www.fixya.com/tags/error_344 Retry the fax reception when telephone line conditions have improved. Fax Error 358 All tests show "pass." HP Support Forums Join in the conversation. Hp Fax Error 321 Do not use call waiting on a line with a fax machine.

Prev12Next » Not finding what you are looking for? this contact form Retry the fax reception when line conditions might have improved. This website compatible with ie7, ie8, ie9, ie10, ie11, firefox and google chrome. All rights reserved. Fax Error 388

All tests show "pass." Options Mark as New Bookmark Subscribe Subscribe to RSS Feed Highlight Print Email to a Friend Report Inappropriate Content ‎08-14-2012 04:57 PM Reply 0 Reply 0 0 -JohnB- Distinguished Professor Posts: 5,287 Member Since: ‎11-22-2011 Message 2 of 2 (1,930 Views) Report Inappropriate Content Re: Error 344 when faxing with HP 8600. Ask the remote machine user to reset the remote machine. I have done the following (according to a previous post):1. have a peek here Hp Officejet 5610 will cause to program lock-ups, slow PC performance, system freezes and crashes, etc.

This error might be associated with bad line conditions or might indicate a problem with the fax's modem. Hp Fax Error 350 Try sending the fax again. 312 A remote fax machine failed to answer the call. Enable or disable the ECM setting.

For that reason, it slows down your computer system after some time.

Call the telephone provider if line conditions fail to improve. However, if you get these error codes frequently when faxing with your HP Officejet there is likely a communication issue occuring with your fax line. Or just drag it here! Fax Error 346 Try the fax when telephone line conditions have improved.

They set up another and it works perfect! If this is the case, ask the sender to retry a normal transmission from the remote machine. If faxes are successfully sent to and received from other machines, but not this particular remote machine, then the issue is probably a problem with the remote machine. 252 Telephone line conditions were too poor to receive a fax. http://orgias.org/fax-error/hp-officejet-5610-fax-error-388.html Try relocating the fax to a differnt phone plug.

In some cases this error can occur if the other fax machine is using a fax format incompatible with the HP fax. 422 423 A handshaking (connection) error occurred at some point in the process from the receiving fax machine. Turn both the sending and the receiving machine off for ten seconds, turn them on, and then try sending again. Prev123456Next » Not finding what you are looking for? To avoid from further damage to your computer, it is important to remove the errors in time.

A Officejet 5610 Error 350 error code is caused by a Hexadecimal formatting error. There may be various factors behind Hp Officejet 5610 error, including:excessive startup entriesregistry errorshardware/RAM declinefragmented filesneedless program installations, etc Recommend Solution to Fix "Hp Officejet 5610". Casper Mattress Vs Sealy casper mattress vs sealy - Unbiased bed box mattress reviews ratings 2015, Sleep like the dead reviews and rates bed in a box mattresses ba... Confirm that the remote caller is a fax machine and not a voice call.

This error is very rare because normally a remote machine does not answer if it cannot receive a document. Manufacturers and developers of software apps and hardware drivers use different codes to indicate various types of errors. If this error only occurs with one specific fax number, but you're able to send to all other fax numbers just fine, than the issue likely lies with thereceiving ends fax machine. Enable ECM on both the local machine and the remote machine. 231 The remote machine attempted to initiate a transmission to the local machine, but the receive capability was disabled at the local machine.

The click, heard for an incoming call, is actually a momentary disconnect of the line. I am getting error code 344. Errors might still occur, and might result in a degraded image quality on the received page. The remote machine temporarily disabled answering due to a condition such as lack of paper or a paper jam.

Software program problems. The faster transmission speeds can cause fax packets of information to be lost in the sending orreceiving process. Reply 0 0 « Message Listing « Previous Topic Next Topic » Related Documents HP Printers - Using HP Diagnostic Tools for HP Printers in WindowsHP Printers - After Windows 10 Upgrade, Printer Does Not PrintHP Printers - Using Google Cloud Print with Your HP PrinterHP Printers - Printer is Offline (Windows)HP LaserJet Pro Printers and Multifunction Printers - HP Smart Install Discontinuation Videos Related Step by Step Guides Help with Clearing Paper Jams HP LaserJet PrintersPrint Job Stuck in Queue (OS not known)Print Job Stuck in Queue (Windows) Print Job Stuck in Queue (Mac) English Open Menu English Deutsch Español Français Português 中文 한국어 † The opinions expressed above are the personal opinions of the authors, not of HP. Also make sure the remote machine is attempting to initiate a transmission and not a reception. 243 244 The user of the remote machine pressed the Stop key, causing the session to be prematurely terminated.

Confirm that the remote fax machine is ready to receive a document, and then try sending the fax again. 313 A busy signal was detected each time the local machine attempted to call the remote machine. However, the ability to send the entire document improves. 329 330 331 The remote machine reported that one or more pages were received (non-ECM mode) with excessive errors. This occurs during ECM transmission after trying repeatedly to send a fax.